Settings; Function Settings; F. Adj - Panasonic YD-500GP5 Operating Instructions Manual

8 Settings

8.1 FUNCTION settings

8.1.1

"F. ADJ"

The following table shows the pages and parameters for fine adjustment/settings using the "F. ADJ".
(1) Use the Mode selection key ○
and 00 in ○
.
5
○
(2) In , select the item (P00～P29) to be changed.
4
○
It shows item in and set value in
2
○
Note please don't turn
○
in can change.)
5
(3) When you want to change the set value of the selected
○
item, turn , The set value is shown in
7
(4) After operation, select the other mode than "F. Adj"
According to (3) operation, you can decide the set value
Note the circled digits are in correspondence with that of
the parts on the right drawing. On F.Adj status, welding is not
enabled but gas check function works.
【Basic Control】
NO. Menu contents
P00
SLOW DOWN
PRE FLOW
P04
TIME
AFTER FLOW
P05
TIME
UNITARY·
P10
respectively
External remote
P11
control
Loop resistance
P12
※ 2
Compute
to select F. Adj. (During welding, it can NOT be selected.) It shows P00 in ○
12
○
.
5
Jog-dial arbitrarily. (The set value
7
○
.
5
Set range Increment
※ 1
-5 ～5
0.1
-5 s～5 s 0.1s
-5s～5 s 0.1s
0 or 1
0 or 1
0 or 1
Settings
Default
Fine adjustment of slowdown speed. Increase the
0.1
set value to increase the slow-down speed.
It specifies time to feed wire after starting gas
0.1s
supply by turning on the torch switch.
It specifies time to stop gas supply after stop-ping
0.1s
the arc by turning off the torch switch.
1: Welding voltage unification;
1 1
0: The welding voltage is respectively.
1: The power supply preset current and preset
voltage are adjusted by the operation panel
encoder;
1 0
0: The power supply preset current and preset
voltage are adjusted by the wire feeder remote
control.
When set to 1, the mode selection key ○
selected for soldering. Make sure the contact tip is
1 0 in close contact with the base material. Press the
torch switch. The digital tube
corresponding resistance value (unit: 0.0001Ω).
32
Note
is
1 2
○
shows the
5
2