Repair; Replacing The Brake - ABB FlexPendant Product Manual

4 Repair

4.1 Replacing the brake

Introduction
The brake limits the rolling speed when retracting the cable. The brake loses power
gradually over time and should be replaced.
If the brake is not working, then the FlexPendant can be damaged if the retraction
is so strong that the operator loses his grip.
xx1300002383
Replacing the brake
Use this procedure to replace the brake on the FlexPendant Retractable Cable.
1
Product manual - FlexPendant Retractable Cable
3HAC048816-001 Revision: B
CAUTION
Action
Retract the cable so that all cable is inside the
housing.
© Copyright 2015-2016 ABB. All rights reserved.
4 Repair
4.1 Replacing the brake
Note
Continues on next page
37