Groomer Arm Assembly - Toro Greensmaster Flex 21 Service Manual

Groomer Arm Assembly

2
Antisieze
Lubricant
1. HOC groomer arm (LH shown)
2. Flange nut
3. Grooved pin
4. E–ring
5. Groomer lift rod
Disassembly
1. Remove groomer arm from cutting unit (see Groom-
er Reel Removal in this section).
2. Disassemble groomer arm using Figure 17 as a
guide.
NOTE: Right and left side HOC groomer arms and lift
arm assemblies are different; other components shown
in Figure 17 are the same on both sides of machine.
NOTE: Grooved pin (item 3) is used to retain lock screw
(item 6) to lift arm assembly.
Greensmaster Flex 21
1
3
4
Antisieze
Lubricant
Figure 17
6. Lock screw
7. Bushing
8. Lift arm assembly (LH shown)
9. Detent spring
10. Spring washer
Page 9 – 15
14
13
7
12
8
Antisieze
Lubricant
5
11. Cap screw
12. Bushing
13. Wave washer
14. Groomer adjuster
Assembly
1. Apply antisieze lubricant to threads of groomer lift
rod (item 5) and lift arm assembly (item 8). Assemble
groomer arm using Figure 17 as a guide.
2. Install groomer arm onto cutting unit (see Groomer
Reel Installation in this section).
3. Check height–of–cut and adjust as needed.
Groomer (Model 04204) (Rev. B)
11
10
9
7
6