Toro Greensmaster Flex 21 Service Manual page 77

Handle Removal
1. Park mower on a level surface. Make sure engine is
OFF. Remove high tension lead from the spark plug.
2. Cut cable ties that secure cables.
3. Disconnect:
A. Reel control and traction cables from gearbox
(see Cable Replacement in this Chapter).
B. Parking brake cable from brake bracket assem-
bly (see Cable Replacement in this Chapter).
C. Throttle cable from engine (see Throttle Cable
Replacement in this Chapter).
D. Interlock switch wire connection.
4. Loosen and remove flange nut from cap screw on
each end of the handle (Fig. 4).
5. Remove handle from frame.
Handle Installation
1. Slide handle ends through the holes in the handle
arms with grommets. Install handle to the frame using
cap screw, pivot pin, and flange nut on each side.
2. Attach and adjust:
A. Reel control, traction, and parking brake cables
(see Cable Replacement).
B. Throttle cable (see Throttle Cable Replacement).
C. Interlock switch wire connection.
3. Secure cables with cable ties.
Greensmaster Flex 21
2
4
5
1. Handle end
2. Handle arm w/grommet
3. Hairpin cotter
8
7
1. Handle
2. Handle arm
3. Handle grommet
4. Handle support spacer
5. Pivot pin
Page 6 – 5
1
3
6
Figure 3
4. Ring pin
5. Cap screw
6. Pivot pin
1
3
2
RIGHT
4
9 FRONT
6
5
Figure 4
6. Flange nut
7. Cap screw
8. Ring pin
9. Hairpin cotter
Chassis and Controls