Exchanging Hard Disk With Damper - Bosch Rexroth IndraControl VSB 40.1 Project Planning Manual

66/83 Bosch Rexroth AG
Maintenance and Installation
8.4.4

Exchanging Hard Disk with Damper

10. Now remove the old hard disk and insert the new hard disk.
11. Plug-in the cables at the hard disk and, if necessary, at the CD-DVD drive.
Connection pins must not be bent!
NOTICE
Check the cable connections leading to the hard disk for tightness.
12. After plugging-in the cables, put the VSB 40.1 again in the mounting plate
(mounting frame). Do not squeeze any cables.
13. Connect the mounting plate (mounting frame) and the VSB 40.1 with the
four screws.
14. The new hard disk parameters are automatically identified by the system.
If the operating system does not boot automatically, interrupt the power
supply for at least 10 seconds. A restart must be carried out again.
15. Restore the user data as well as the operating system settings for the
normal mode after a regular boot of the PC.
In case of VSB 40.1 devices containing hard disks with damper, it is located
below the device, see fig. 8-13 "Location of the hard disk with damper" on page
66.
Fig.8-13: Location of the hard disk with damper
To be able to replace the hard disk, remove the fastening screw of the hard disk
frame on the bottom side of the VSB 40.1, see
disk frame and of the fastening screw" on page
somewhat, see ② in fig. 8-14 "Position of the hard disk frame and of the fas‐
tening screw" on page 67. After releasing the retaining spring, unplug the
ribbon cable, with which the hard disk is connected to the main board. Now the
DOK-SUPPL*-VSB*40.1***-PR03-EN-P
Rexroth IndraControl VSB 40.1 Control Cabinet PC
Possible malfunction or no function if ca‐
ble connections leading to the hard disk
do not fit correctly.
fig. 8-14 "Position of the hard
67. Lift the hard disk frame