Advertisement
You will only be able to load and eject video cassettes when your VCR is plugged into the mains.
Your VCR may also play back recordings from NTSC tapes (on PAL TV).
Getting a better picture
When a cassette is inserted and playback started, the automatic tracking function works to get
the best possible picture automatically. If the quality of the recording is poor, repeatedly press M
or L on the remote control to manually adjust the tracking until any distortions have been
removed. Press numbered 0 on the remote control to switch automatic tracking back on again.
Make sure that you have
correctly connected your
VCR as described earlier
in this book.
Turn on your TV and
select the video channel
for video playback.
Press POWER to turn on
your VCR.
EJECT
POWER
Insert the video cassette
into your VCR.
The video cassette should
have the window side facing
up and the arrow facing
away from you.
Press PLAY to start
playing your tape.
REW
FF
PLAY
REC/
If you load a video
cassette which has had its
record protection tab
removed playback of the
cassette will start
automatically.
AUTO TRACKING
Your VCR will automatically
adjust the tracking to give
the best picture quality.
Still picture :
Press P/STILL to pause
a picture.
Press P/STILL
repeatedly to advance
the still picture frame by
frame.
D
E
Press
or
to reduce
the vertical tremble
during still picture.
CLEAR
OK
i
CLK/CNT
REW
FF
Tapes can be paused for
up to 5 minutes. After 5
minutes your VCR will
stop playing the tape to
prevent damaging the
tape or your VCR .
Press PLAY to continue
playing your tape.
Picture search:
During playing back
press either FF or REW
to this will enable you to
rapidly wind the tape (7
times normal playback
speed) and see where
you are on the tape.
Logic search:
During fast forwarding or
rewinding press and hold
FF or REW the picture
will be played back at 7
times normal playback
speed.
HORLOGE
COMPT
REW
FF
PLAY
17
Advertisement
