Advertisement
The output frequency of
this video recorder (VCR)
is set at UHF channel 22.
If channel 22 is already
used by another TV
station, or if the picture is
distorted, you can
change the transmitter
channel of your VCR.
Stages 5~8 will show you
how to change the output
frequency of your VCR.
8
Your TV receives signals from the video recorder (VCR) like another TV station.
You have to select a channel number on your TV and tune it in so that you may watch video
tapes.
If you have used a SCART or AUDIO and VIDEO cables then your TV should already have
a dedicated video channel built into it, usually called AV.
Make sure that you have
Insert a pre-recorded
correctly installed your
video tape into your VCR
VCR as described earlier
and press PLAY on the
in this book.
remote control.
Select a TV channel
Press POWER to turn on
number on which you
your VCR.
wish to watch video's.
Turn on your TV.
Don't worry if you don't have
a video-tape to play at this
stage!
If you switch your VCR on
and continue stages 3~4,
instead of seeing video
playback tune your TV until
you see a bright blue
screen.
Tune this channel until
the video picture is sharp
and the sound is clear.
If you have used a SCART
or AUDIO and VIDEO cables
you will not have to tune your
TV, simply select the AV
channel. The AV channel is
already pre-tuned for opti-
mum video playback on your
.
TV
REW
FF
PLAY
REC/
Store this channel on
your TV.
You will need to look at the
TV instruction book if you do
not know how to do this.
D
OK i
Advertisement
