FusionModule1000A40 Prefabricated All-in-One
Data Center
Product Description (Advanced Configuration, 208
V)
Figure 3-37 Layout of management system components
(1) Camera (monitors the long
aisle)
(4) Access actuator
(7) PAD
The ECC800 is deployed in the Rack-A1 cabinet.
3.4.2 ECC800-Pro
3.4.2.1 Product Configuration
The ECC800-Pro data center controller is used to monitor the devices and
environment in the smart module. It consists of the power module and main
control module. You can insert and remove the power module.
You can configure the ECC800-Pro collector in the following two manners:
Configuration 1 (typical configuration): one power module and one main control
module
Configuration 2: two power modules and one main control module.
● In configuration 1, install a filler panel in slot 2.
● In configuration 2, install power modules in slots 1 and 2.
Issue 03 (2021-02-10)
NO TE
NO TE
Copyright © Huawei Technologies Co., Ltd.
(2) Rack-A1 cabinet
(5) AC actuator
(8) Water sensor
3 Architecture
(3) Smart ETH gateway
(6) Camera (monitors the
entrance room and main
entrance)
45