Multi-Part Forms - Epson FX-870 User Manual

Printing on Special Paper
Use the following table to set the paper-thickness lever to match the
thickness of your paper:
Paper type*
Ordinary (Single sheets or continuous)
Thin paper
Carbonless multi-part forms
2 sheets (original + 1 copy)
3 sheets (original + 2 copy)
4 sheets (original + 3 copy)
Labels
Envelope
See Chapter 7 for complete paper specifications.
*
Note: Print speed is reduced for paper-thickness lever settings of
2 and above.

Multi-part forms

You can use carbonless multi-part forms of up to four parts
(including the original). Make sure you set the paper-thickness lever
to the proper position based on the number of parts in your form.
Except for the paper-thickness setting, you load multi-part forms the
same way as ordinary paper. For details, see the sections on loading
continuous paper earlier in this chapter. Pay special attention to
setting the top-of-form position.
0 t
CAUTION: Be sure the multi-part forms do not exceed
0.32 mm (0.0128 inches) in thickness.
l
2-24 Paper Handling
Lever position
2
2 to 5