Adjusting The Tear-Off Position - Epson FX-870 User Manual

4. When you resume printing, the printer automatically feeds the
paper back to the loading position and begins printing. (You can
also manually feed the paper back to the loading position by
TEAR OFF
pressing the

Adjusting the tear-off position

If the paper's perforation does not meet the tear-off edge, follow the
steps below to adjust the tear-off position:
1.
Make sure the paper is in the tear-off position and the
light is blinking.
While holding down the
2.
enter the micro-feed feature. The
blink alternately.
PAUSE/TEAR OFF
Press the
3.
down on the page, or press the
tear-off position up on the page. The printer remembers the new
tear-off position even after you turn off the printer.
Tear off any printed pages.
4.
When you begin printing, the printer automatically feeds the
5.
paper back to the loading position and begins printing.
Note:
The printer has a minimum and maximum tear-off position. If
l
you try to advance the loading position beyond the limits, the
printer beeps and the paper stops moving.
When the paper reaches the factory-set tear-off position, the
l
printer beeps and paper feeding pauses briefly. Use the
factory setting as a reference point when you adjust the tear-
off position.
3-20 Using the Printer
button again.)
ALT
button, press the
FONT
and
button to move the tear-off position
PAPER FEED
Tear Off
READY
PAUSE
button to
CONDENSED
lights
button to move the