Panasonic BB-HCS301A Troubleshooting Manual page 11

Problem
A gray screen is • A copyguard signal was detected. This image cannot be
displayed. displayed.
• No input signal.
Video suddenly • The video (Motion JPEG) display period is set on the General
changes to still User page.
images.
The color on the • The color display setting on your PC is set lower than 16 bits.
image is
strange.
Image flickers. • The environment surrounding the object is dark.
• The color display setting on your PC is set lower than 16 bits.
A whitish and • The cable is connected to the video output terminal, but the
unclear image is opposite side of the cable is not connected.
displayed.
• The monitor has a termination resistor switch, and the switch is
off (HI-Z).
The vertical and • The cause is the fluctuation of the camera's video output.
horizontal black
lines appear on
the image.
All manuals and user guides at all-guides.com
Cause and Remedy
Input the images without copyguard to this product's video
input terminal.
Input the video output from the camera to this product's input
terminal.
It is a normal operation. When you view video continuously,
set [Unlimited] for the limit continuous motion JPEG (see
page 78 of the Operating Instructions on the Setup CD-
ROM).
Set the color display 16 bits or higher.
Brighten the area around the object.
Set it to 16 bit high color or greater.
Correctly connect the cable to the input terminal of the
monitor. If unnecessary, remove the cable from this product's
video output terminal.
Turn the termination resistor switch off (75 Ω).
To erase the black lines, adjust the picture position (see page
67 of the Operating Instructions on the Setup CD-ROM).
[For assistance, please call: 1-800-272-7033]
Troubleshooting
11