Maintenance Of Safety Module; Maintenance Of Hose Breakaway Device - Bosch Rexroth APAS assistant K1100-10i Installation Instructions Manual

9.4 Maintenance of safety module

Inspect all lines, connections and shield supports for loose connections, abrasion
„
points and damage following maintenance work, and immediately remedy any
found defects.
Maintenance work Cleaning agents/Notice
Check state of safety
„
module. If you find any damage or wear:
„
Inspect sensor skin „
channels.
„
Inspect sensor skin „
safety circuits.
„
Replace filter inserts on
„
fan.
Replace fan. „

9.5 Maintenance of hose breakaway device

Inspect all lines and connections for loose connections, abrasion points and
„
damage following maintenance work, and immediately remedy any found defects.
Maintenance work Cleaning agents/Notice
Check state of hose „
breakaway device. If you find any damage or wear:
„
If you find that the pneumatic lines rub against
the sensor skin or other components:
„
Cleaning the hose Moist cleaning cloth and mild cleaning agents or
breakaway device aspirated air.
„
„
3 842 565 050/2019-11 APAS assistant K1100-10i V01.00.00 - V01.00.99, Bosch Rexroth AG
Perform a visual inspection.
Contact the APAS service.
Contact the BCI Training Center and take the
training course on sensor skin maintenance
[BCI-SP-AP015].
After successful completion of training:
Perform the inspection according to the
inspection instruction Sensor skin safety
circuits Version V01.02.00 (or higher).
Contact the BCI Training Center and take the
training course on sensor skin maintenance
[BCI-SP-AP015].
After successful completion of training:
Perform the inspection according to the
inspection instruction Sensor skin safety
circuits Version V01.02.01 (or higher).
Observe the vendor documentation of
RITTAL GmbH & Co. KG.
Observe the vendor documentation of
RITTAL GmbH & Co. KG.
Visually inspect all components.
Immediately replace the affected
components (see "Installing the hose
breakaway device" on p. 36 and the hose
breakaway device data on p. 25).
Change the hose placement.
Observe the safety measures.
Define a maintenance interval for cleaning
depending on the application.
Servicing and repair 63/68
Interval
Yearly
Yearly
Yearly and
following all
modification work
To be defined by
the operator
To be defined by
the operator
Interval
Daily
As needed