Epson 802.11g Reference Manual page 220

You cannot use the bindery print server mode with EpsonNet
Config if you are running Novell Client for Windows 95/98
version 3.00 or Novell Client for Windows NT version 4.50.
To configure the network interface for bindery mode, use
Novell IntranetWare Client or EpsonNet Config with Web
Browser.
See your NetWare documentation for more information.
Time required to recognize the network interface
It takes up to two minutes for the NetWare server to recognize
the network interface, after the device is turned on. During
this start-up time, the status sheet does not show the correct
information.
Frame type
The same frame type should be used for the NetWare server
and IPX router on the same network. If more than one frame
type is used on the same network, bind all the frame types to
the NetWare servers and IPX routers.
For NetWare 5.x
The IPX protocol must be installed (bound) on the
NetWare 5.x server.
About modes
If the mode you have logged in is different from the mode you
set for the network interface, a message appears when you try
to configure the network interface for NetWare. If you do not
want to change the current settings, click Cancel and log in
again using the same mode set for the network interface.
220