Residential Gateway - D-Link DVA-2800 User Manual

Section 4 - Configuration
Your DVA-2800 is equipped with a Gigabit Ethernet WAN port which can be used to connect
to the Internet. This port may be used to connect to other Ethernet based networks. In
order for your DVA-2800 to use Ethernet, you must configure the Ethernet Settings, VLAN
Settings, and your IPv4/IPv6 Settings.
Select Residential Gateway to configure Ethernet connection
WAN Access Type:
settings.
Interface: Select the interface from the drop-down menu. ETH0-ETH5 are
available. The default is ETH0.
Enable Interface: Select whether to enable or disable this interface.
VLAN Settings
VLAN Tagged:
Enable or disable VLAN tagging.
If you enabled VLAN Tagged, the following options are available:
VLAN ID:
Enter the VLAN ID. The value should be 0, or 0-4079.
VLAN Priority:
Enter the VLAN Priority from the default 0 (lowest) to 7 (highest).
Service Type: Select a service type from the list. Choose from INTERNET, VOIP,
INTERNET_VOIP, TR069, TR069_INTERNET, or INTERNET_VOIP_
TR069. This information should be provided by your ISP. If you are
configuring your connection manually and your ISP has not specified
this setting, selecting INTERNET is recommended.
Proceed to IPv4 Settings on page 33 or IPv6 Settings on page 38.
D-Link DVA-2800 User Manual

Residential Gateway

31