D-Link DVA-2800 User Manual page 40

Section 4 - Configuration
Advanced Settings
Address Mode: Select Static IP if your ISP assigned you an IP address, subnet mask,
gateway, and DNS server addresses. In most cases, select Dynamic IP.
IP Address: Enter the IP address provided by your ISP. Static IP only.
Service Name: Enter the ISP service name (optional).
Primary DNS Enter the primary DNS server IP address assigned by your ISP. This
Server: address is usually obtained automatically from your ISP.
Secondary DNS Enter the secondary DNS server IP address assigned by your ISP. This
Server: address is usually obtained automatically from your ISP.
MTU: Maximum Transmission Unit - you may need to change the MTU for
optimal performance with your ISP.
Enable NAT: Enable or disable Network Address Translation.
Proceed to IPv6 Settings on page 38 or click Save when you are done.
D-Link DVA-2800 User Manual
PPPoE/PPPoA (Cont)
IPv4 SETTINGS
My Internet Connection is: PPPoE (PPPoA)
Username:
Password:
Reconnect Mode: Always On
Address Mode: Dynamic IP
Service Name:
Primary DNS Server:
Secondary DNS Server:
MTU: Auto
Enabled
Enable NAT:
Address Mode: Static IP
IP Address:
Service Name:
Primary DNS Server:
Secondary DNS Server:
MTU: Auto
Enabled
Enable NAT:
⌵
⌵
Advanced Settings ...
⌵
⌵
⌵
⌵
36