HP EliteDesk 800 G3 SFF Maintenance And Service Manual page 53

5. To remove an M.2 SSD card, remove the screw that secures the card (1), lift the end of the card up (2),
and then slide the card out of the system board connector (3).
6. To install an M.2 SSD card, slide the pins on the card into the system board connector while holding the
card at approximately a 30° angle (1). Press the other end of the card down (2), and then secure the card
with the screw (3).
7. Rotate the drive cage back down to its normal position.
IMPORTANT: Be careful not to pinch any cables or wires when rotating the drive cage down.
8. Reassemble the computer.
Drives 45