D-Link Covr-C1203 User Manual page 50

Section 3 - Configuration
DHCP Server
Enable or disable the DHCP server.
Status:
Enter the starting and ending IP addresses for the DHCP server's IP
DHCP IP Address
assignment.
Range:
Note: If you have reserved static IP addresses to client devices, make
sure the IP addresses are outside of this range or you might have an IP
conflict. Refer to Connected Clients section 14 for how reserve IP
addresses for clients.
Enter the length of time for the IP address lease (in minutes).
DHCP Lease Time:
Enable this feature to broadcast your network's DHCP server to LAN/
Always Broadcast:
WLAN clients.
Advanced Settings
You may set the port speed of the Internet port to 10 Mbps, 100
WAN Port Speed:
Mbps, 1000 Mbps, or Auto (recommended).
Enable or disable Universal Plug and Play (UPnP). UPnP provides
UPnP:
compatibility with networking equipment, software, and peripherals.
Enable to allow IPv4 multicast traffic to pass through Covr Point A
IPv4 Multicast
from the Internet.
Streams:
Enable to allow IPv6 multicast traffic to pass through Covr Point A
IPv6 Multicast
from the Internet.
Streams:
Click Save when you are done.
D-Link COVR-C1203 User Manual
Network (Continued)
46