System Admin; Admin - D-Link Covr-C1203 User Manual

Section 3 - Configuration
This page will allow you to change the administrator (Admin) password and
enable the HTTPS server. In the Management menu on the bar on the top of
the page, click System Admin.
Admin Password
Enter a new password for the administrator account. You will need to
Password:
enter this password whenever you configure Covr Point A using a web
browser.
Enables a challenge-response test to require users to type letters or
Enable Graphical
numbers from a distorted image displayed on the screen to help prevent
Authentication
online hackers and unauthorized users from access to your network.
(CAPTCHA):
Advanced Settings - Administration
Check to enable HTTPS to connect to the extender securely. Instead of
Enable HTTPS
using http://covr.local./, you must use https://covr.local./ in order to
Server:
connect to Covr Point A.
Note: If you previously changed the management link in the Network
section, replace covr.local./ with the new management link.
Remote management allows Covr Point A to be configured from the
Enable Remote
Internet by a web browser. A password is still required to access the web
Management:
management interface.
The port number used in the URL to access Covr Point A.
Enable Admin
Example: http://x.x.x.x:8080 where x.x.x.x is the Internet IP address of Covr
Port:
Point A and 8080 is the port used for the web management interface.
Note: If you enabled Use HTTPS and wish to access Covr Point A remotely
and securely, you must enter https:// at the beginning of the address.
D-Link COVR-C1203 User Manual

System Admin

Admin

64