Set the Horizontal Position
Ⓔ
1. Loosen the knob
left monitor
2. Move the left monitor so that the edge of the monitor
lines up with the center of the pole
Ⓔ
3. Tighten the knob
horizontal position
4. Make sure the monitor does not tilt forward It should
be completely vertical when viewed from the side
If necessary, loosen knob
adjustment
iutn:
the instructions in this section are for the
monitors to be set up as a flat surface. instructions for
tilting the monitors are under "adjust tilt / swivel /
Pivot" on page 16.
on the back of the arm for the
on the back of the arm to fix the
Ⓓ
and fine tune the
2 x 2 mUlti-monitoR installation (K3F220/K3g220) | 11
Ⓔ
Ⓓ
CHIEF STAND INSTALLATION MANUAL | USER'S GUIDE