2. Position the arm to the approximate height matching
the lower-center monitor
3. Tighten only the hex screw
4. Repeat steps 1-3 for the lower-right monitor
5. Loosen the hex screw
left and right VESA plates so they can be adjusted
by hand
ⓘ
loosen the hex screw, do not remove it.
6. Adjust the tilt-angle of the VESA plate parallel to the
arm surface Do not rotate the plate
7. Completely tighten hex screw
8. Loosely tighten knob
position of the VESA plate
Ⓒ
Ⓒ
Ⓓ
Ⓔ
and knob
of the lower
Ⓓ
Ⓔ
when finished setting the
3 x 2 mUlti-monitoR installation (K3g320) | 28
Ⓔ
Ⓓ
CHIEF STAND INSTALLATION MANUAL | USER'S GUIDE