Installing The Center Monitors; Set The Center Vesa Plates Position - NEC CHIEF K3F220 Installation Manual

Installing the Center Monitors

Set the Center VESA Plates Position

Ⓐ
1. Loosen hex screw
plate for height adjustment
ⓘ
loosen the hex screw, do not remove it.
2. Adjust the height of the lower-center VESA plate to
the desired level
Make sure the plate is high enough that the monitor
will not touch the table after it is attached
3. Completely tighten hex screw
of the lower-center VESA
Ⓐ
3 x 2 mUlti-monitoR installation (K3g320) | 21
Ⓐ
CHIEF STAND INSTALLATION MANUAL | USER'S GUIDE