2 - 4
Function check
If a maIfunction occurs a message is indicated at the display, see "Service Instructions,
chapter Display messages".
Functional test cable winder
•
Disconnect the power supply plug.
•
Pull the left handle (for the cable winder) upwards.
•
Move the cable up and down while rewinding it, in order to avoid any slack, until the cable
is completely rolled up. Check proper function of cable winder and brake.
•
Pull out the cable and connect the power supply plug.
Functional tests with motor drive
•
Test the forward/ reverse and fast (1 m/s) / slow (0.5 m/s) controls.
NOTE
Speed Adjustment (if necessary)
•
Remove the plastic plug above and to the left of the supporting wheels on the cover with
the cassette compartment (for details see the Service Instructions).
•
Use a screwdriver and adjust the speed by potentiometer on D101:
- turn clockwise (CW) for slower speed.
- turn counterclockwise (CCW) for faster speed.
NOTE
MOBILETT Plus HP
For adjustment, see chapter "Speed Adjustment".
This will effect the slow/fast speed simultaneously.
SPR8-220.033.03
Rev. 02
Installation and setting
Page 4 of 12
10.02
SPS-UD
2
2
2
2
Siemens-Elema AB
Solna, Sweden