Installing The Transducer - Toro LT2240 Installation Instructions Manual

2. Loosely assemble the mounting bracket to the
latch plate (Figure
x 25 mm) and flange locknut (6 mm).
3. Loosely assemble the mounting bracket to the
pivot-arm plate (Figure
bolt (8 x 30 mm) and flange locknut (8 mm).
4. Repeat steps 2 and
bracket.
5. Torque all 6 mm bolts and locknuts
to 11 to 13 N∙m (97 to 115 in-lb).
1. 6 mm flange-head bolt and
locknut
6. Torque all 8 mm bolts and locknuts
to 26 to 30 N∙m (16 to 22 ft-lb).
8
Installing the
Brake-Pressure Transducer
Parts needed for this procedure:
1 Pressure transducer
1 Fitting (3/4 x 7/16 inch)
1 Adapter fitting (1/4 x 7/16 inch)
Seal (1/4 inch)—For Machines with the Differential
1
Lock Kit installed only

Installing the Transducer

Model 31654
1. At the right side of the traction pump, remove
the plug from the T-fitting at port B of the traction
pump (Figure 31).
30) with a flange-head bolt (6
30) with a flange-head
3 at the other mounting
(Figure
Figure 30
2. 8 mm flange-head bolt
bolts and locknuts
(Figure
30)
g344584
30)
1. T-fitting (traction pump
port B)
2. Plug
2. Assemble the adapter fitting (1/4 x 7/16 inch)
into the T-fitting
3. Torque the assemble the adapter to 34 to 41
N∙m (25 to 30 ft-lb).
4. Assemble the brake-pressure transducer into
the adapter fitting
12
Figure 31
3. Adapter fitting (1/4 x 7/16
inch)
(Figure 31).
(Figure 32).
g344293
g344289