Toro LT2240 Installation Instructions Manual page 18

Assembling the Number Plate and
Light
1. Place the assembled number-plate bracket
onto the bulkhead and align the bracket as far
forward as possible.
2. Center the assembled number plate on the
bulkhead.
3. Using the bracket as the template, drill 2 holes
(7 mm) through the bulkhead
Figure 48
1. Drill 2 holes (7 mm) in the bulkhead.
4. Drill a hole (6.5 mm) through the bulkhead to the
left of the number-plate light
Figure 49
1. Drill a hole (6.5 mm)—bulkhead.
5. Loosely assemble number-plate bracket to the
bulkhead using 2 flange-head bolts (6 x 20 mm),
(Figure 48).
g347227
(Figure 49).
g347228
18
3 washers (1/4 x 3/4 inch) , and a flange locknut
(6 mm) as shown in
You will install the locknut to the machine left
flange-head bolt in
Harness to the Bulkhead (page
Figure 50
1. Flange-head bolt (6 x 20
mm)
2. Washers
6. Route the harness of the number-plate light
(Figure 51) through the hole (6.5 mm) that you
drilled in step 4.
Note:
You will install the 2-pin connector
and wedge lock in
Connector (page 19).
Figure 51
1. Harness (number-plate
light)
Figure 50.
Securing the Plate-Light
19).
3. Flange locknut (6 mm)
4. Machine right—bulkhead
Assembling the Plate-Light
2. Hole (6.5 mm—bulkhead)
g349858
g346837