Toro LT2240 Installation Instructions Manual page 5

Figure 5
1. Pivot bolt (16 x 100 mm)
2. Secure the right, rear light assembly to the roll
bar using the new bolt (16 x 110 mm) and new
flange nut (16 mm) as shown in
Figure 6
Right side shown
1. New bolt (16 x 110 mm)
2. Right, rear light assembly
3. Repeat this procedure on the left side of the roll
bar.
g344223
2. Flange nut (16 mm)
Figure 6.
g344222
3. New flange nut (16 mm)
3
Installing the Reflectors
Parts needed for this procedure:
2 Reflector
Procedure
Remove the backing film and mount the 2 reflectors to
the back of the hood as shown in
Reflector location for Model 31654
Reflector location for Model 31657 and 31659
5
Figure 7 or Figure
Figure 7
Figure 8
8.
g344248
g344249