Completing The Installation; Operation; Adjusting The Headlights; Operating The Lights - Toro LT2240 Installation Instructions Manual

16

Completing the Installation

No Parts Required
Closing the Hood
Models 31654
Close and latch the hood.
Installing the Control-Arm Cover
Models 31657 and 31659
Install the control-arm cover
Phillips-head screws (1/4 x 1 inch) that you removed
in Installing the Switches (page
Figure 89
1. Phillips-head screw (1/4 x
1 inch)
(Figure 89) with the 2
7).
g344284
2. Control-arm cover

Operation

Adjusting the Headlights

Adjust the headlights so that the horizontal part of the
cut-off of the beam is tilted downward at 2.0%.
1. Loosen the nut that secures the headlights to
the bracket.
2. Adjust the headlights into position by hand.
3. Tighten the nut to hold the light in the correct
position.

Operating the Lights

Lights Symbols
The lights controls are marked with the symbols
shown in Figure 90.
1. Hazard warning
2. Direction indicators
Headlight and Marker Lights
The headlights and taillights operate as the position
marker lights.
•
To illuminate the marker lights when the engine is
shut off, press the top of the light switch.
•
To illuminate the headlights and marker lights, run
the engine or rotate the ignition switch to the R
position, and press the top of the light switch.
•
To shut off the lights, press the bottom of the light
switch.
Hazard Lights
Press the top of the hazard light switch to flash all
indicator lamps simultaneously.
Note:
You do not need to have the ignition switch in
the R position to operate the hazard lights.
UN
Direction Indicators
Run the machine with the ignition switch rotated to
the R position, and press the relevant side of the
UN
direction-indicator switch to flash the 2 indicator lamps
at that side of the machine.
33
Figure 90
3. Lights—On/Off
g347124
UN