Toro LT2240 Installation Instructions Manual page 31

Preparing for Calibration
Models 31657 and 31659
1. Inside the control arm, remove the cap from the 3-pin connector of the control-arm harness labeled C
D P
IAGNOSTIC ORT
1. Cap
2. Plug the diagnostic cable into the C
Contact your authorized Toro distributor for a cable.
3. Plug the cable into the computer.
4. Ensure that the parking brake is engaged, and start the engine.
Calibrating the Brake-Pressure Transducer
Models 31657 and 31659
1. Open the Toro Diag program at ToroConnect.
2. Select T:Primary located on the left side of the screen
(Figure 87).
D
AN IAGNOSTIC
Figure 87
2. 3-pin connector (labeled C
harness)
P connector.
ORT
(Figure 88).
31
D P —control-arm
AN IAGNOSTIC ORT
AN
g347123