Fujitsu 420D User Manual page 103

S e c t i o n F i v e
Problem
96
Possible Cause
5. Power Switch not actually in the On Position.
6. The Battery is faulty and there is no power
adapter (AC or Auto) installed.
7. The battery is low.
Possible Solution
5. Try the Resume Button. If that doesn't work
slide the Power Switch firmly to the rear, pause
and then firmly to the front. If you shut down
your notebook from Windows 95 you are really
in special suspension mode,the power is on
and you can restart with the Resume Button
unless it is disabled.
6. Use the Status Indicator Panel to verify
the presence and condition of the battery.
(See Figure 2-3 on page 17.) If the battery is
indicating a short remove the battery and
operate from another power source or
replace the battery.
7. If the battery is dead there will be a beep
when the Power Switch is turned on and your
notebook will immediately go into Dead
Battery Suspend Mode. (See pages 26–27.)
Check the Status Indicator Panel to determine
the presence and condition of the battery. (See
Figure 2-3 on page 17.) Use a power adapter
to operate until the battery is charged or
install a charged battery.