Huawei NetCol5000-C065 Quick Manual page 10

• All smart cooling products in a teamwork group must be of the same model.
•
Do not directly connect the first and the last smart cooling products to form a ring network.
• A maximum of 32 smart cooling products can be networked in one group. The teamwork
cable between two adjacent smart cooling products must not exceed 10 m.
•
If CAN networking is required onsite, set Enable teamwork CAN resistor for the first and last
smart cooling products to Yes on the screen.
Connecting an FE teamwork network cable
Connect one end of the FE network cable to the
FE port on the main control module, connect the
other end to the POE port on the smart ETH
gateway.
CAN teamwork networking cable
1. Prepare the 8 pin standard network cable, the cable pin sequence requirements are shown
below.
2. Connect the CAN_OUT port of each smart cooling product to the CAN_IN port of the following
smart cooling product using a CAN network cable. After powering on the device, set the Enable
teamwork CAN resistor to Yes for the first and last devices in a teamwork group.
10