Toro LT-F3000 Installation Instructions Manual page 11

2. Torque the swivel nut of the 90° traction
motor-hose fitting to 45 N∙m (34 ft-lb).
3. Assemble the charge pressure-supply hose
(marked CP) onto the straight fitting in port-CP
fitting of the front transmission manifold
28).
Figure 28
1. Charge pressure-supply
hose (marked CP)
2. Straight fitting
(port-CP—front
transmission manifold)
4. Torque the swivel nut of the 90° charge
pressure-supply hose fitting to 16.5 N∙m (13
ft-lb).
5. Assemble the left and right brake-pressure
hoses (marked left PB or right PB) onto the
T-fitting at port-PB of the front transmission
manifold (Figure 29).
Figure 29
1. Right brake-pressure
hose(marked right PB)
2. T-fitting (port-PB)
6. Torque the swivel nut of the brake-hose fittings
to 16.5 N∙m (13 ft-lb).
(Figure
g343021
3. Front of the machine
g343022
3. Left brake-pressure
hose(marked left PB)
5
Installing the Differential
Pressure Hose
Parts needed for this procedure:
1 Straight fitting (3/8 x 3/4 inch)
1 Differential pressure hose
1 Adapter fitting (1/4 x 7/16 inch)
1 Seal (1/4 inch)
Removing the Brake-Pressure
Transducer
Machines with the Optional Road Light Kit
1. At the right side of the traction pump, remove
the 3-pin connector labeled
from the brake-pressure transducer
SENSOR
(Figure 30).
1. 3-pin connector (labeled
BRAKE PRESSURE
—machine wire
SENSOR
harness)
2. Remove the brake-pressure transducer from the
reducer fitting
11
BRAKE PRESSURE
Figure 30
2. Brake-pressure
transducer
(Figure 31).
g343559
g344072