Raising The Platform - Toro LT-F3000 Installation Instructions Manual

3
Removing the Front
Transmission Manifold
No Parts Required

Raising the Platform

1. Move the platform-latch handle
toward the front of the machine until the latch
hooks clear the locking bar.
1. Platform-latch handle
2. Raise the platform
Note:
The gas lift cylinder assists lifting the
platform.
(Figure
Figure 6
(Figure 7).
Figure 7
Removing the Hoses at the Back
of the Transmission Manifold
Note:
Make a note recording the position and
orientation of all hoses, fittings, and electrical
connectors that you disconnect or remove from the
front transmission manifold.
1. At the top of the machine, remove the left
traction-motor hose from the straight fitting in
port-FAL of the front transmission manifold
(Figure 8
6)
g290373
1. Left traction-motor
hose—(mark FAL)
2. Straight fitting
(port-FAL—front
transmission manifold)
2. Plug the left traction-motor hose, apply a piece
of tape to the hose, and write FLA on the tape.
g290372
3. Remove the hydraulic-pump hose from the
90°fitting at port-A of the front transmission
manifold
4
and Figure 9).
Figure 8
Figure 9
3. Front of the machine
(Figure 10).
g342834
g342836