Chapter 9 Operation Example; How To Check The Recording Result; Operation Details - Mitsubishi Electric MELSEC iQ-R Series Introduction Manual

9
OPERATION EXAMPLE
Chapter 3 through Chapter 7 describe the settings and how to start the functions of the recording, reproduction, and analysis
that are the three phases of the system recorder. This chapter shows examples of practical use of the system recorder.
9.1

How to Check the Recording Result

Replay the data sampled by the camera recorder module and video recorded by the camera to predict the error cause, and
then further investigate the cause by analysis.

Operation details

The following shows an operation example to investigate the cause of a device error occurred in the workpiece inspection
process.
GOT
2.
Workpiece
Belt conveyor
1.
Workpieces flow on the belt conveyor.
2.
The limit switch detects the flowing workpiece and its product No., and perform pass/fail inspection.
3.
If any of four causes occurs, such as a failed product generation or detection of multiple workpieces, a device error
occurs.
Device error cause
4.
A device error triggers the data sampled by the camera recorder unit to be saved in the SD memory card.
3. 4.
Network camera
Switch
Workpiece
1.
9 OPERATION EXAMPLE
9.1 How to Check the Recording Result
9
80