Air Filter / Pre-Filter Service - Polaris Sportsman XP 1000 S 2020 Service Manual

AIR FILTER / PRE-FILTER SERVICE

It is advisable to replace the filter when it is dirty.
However, in an emergency, it is permissible to clean the
main filter if you observe the following practices.
• Never immerse the filter in water since dirt can be
transferred to the clean air side of the filter.
• If compressed air is used never exceed a pressure of
40 PSI. Always use a dispersion type nozzle to prevent
filter damage and clean from the inside to the outside.
It is recommended that the air filter and pre filter be
replaced annually. When riding in extremely dusty
conditions, replacement is required more often.
REMOVAL
1. Remove the seat to access the airbox cover.
2. Remove the rubber strap retaining the airbox cover
and open the cover.
3. Remove the air filter assembly from the airbox.
CLEANING
w
1. Slip the pre-filter screen
q
element . Clean the pre-filter with hot soapy water.
2. Rinse and dry thoroughly.
3. Inspect pre-filter screen for tears or damage.
4. Inspect main filter and replace if necessary. If the filter
has been soaked with fuel or oil it must be replaced.
INSTALLATION
1. Inspect airbox cover seal for damage. It should
adhere tightly to the cover and seal all the way
around. Replace seal as needed.
9931493 R03 - 2020-2021 Sportsman XP 1000 S Service Manual
© Copyright Polaris Inc.
off of the main filter
2. Reinstall pre-filter screen over main filter. Be sure the
screen covers entire surface of main filter without
folds, creases, or gaps.
NOTICE
Apply a small amount of general purpose grease to the
sealing edges of the filter before reinstalling.
3. Install air filter assembly into the airbox and position it
correctly before closing the airbox cover.
IMPORTANT
Proper placement of the air filter is important to prevent
air leaks.
4. Close airbox cover and secure cover by installing the
rubber strap.
MAINTENANCE
2
2.21