Valve Inspection - Polaris Sportsman XP 1000 S 2020 Service Manual

ENGINE / COOLING SYSTEM

VALVE INSPECTION

1. Remove all carbon from valves with a soft wire wheel
or brush.
2. Check valve face for runout, pitting, and burnt spots.
To check for bent valve stems, mount valve in a drill
or use "V" blocks and a dial indicator.
3. Check end of valve stem for flaring, pitting, wear or
damage.
4. Inspect split keeper groove for wear or flaring of the
keeper seat area.
NOTICE
The valves can be re-faced or end ground, if necessary.
They must be replaced if extensively worn, burnt, bent,
or damaged.
3.50
5. Measure diameter of valve stem with a micrometer in
three places, then rotate 90 degrees and measure
again (six measurements
specifications.
MEASUREMENT
Valve Stem Diameter:
In: 0.2163" ± 0.0003" (5.495 ± 0.0075 mm)
Ex: 0.2159" ± 0.0003"(5.485 ± 0.0075 mm)
6. Measure valve guide inside diameter at the top
middle and end of the guide using a small hole
gauge and a micrometer. Measure in two directions.
MEASUREMENT
Valve Guide I.D.:
0.217" + 0.0005" - 0.0"
(5.52 + 0.012 - 0.0 mm)
7. Subtract valve stem measurement from the valve
guide measurement to obtain stem to guide
clearance.
NOTICE
The valve guides cannot be replaced. Be sure to
measure each guide and valve combination individually.
9931493 R03 - 2020-2021 Sportsman XP 1000 S Service Manual
total). Compare to
© Copyright Polaris Inc.