Ce Marking; Declaration Of Conformity; Note For The Machine Manufacturer - Bosch Rexroth IndraControl VAU 01.1Z Manual

Project Planning Manual | Rexroth IndraControl VAU 01.1Z
4.4.2

CE Marking

Declaration of Conformity

Note for the Machine Manufacturer

Standard Meaning
EN 60 529 Degrees of protection (including housings and installation
compartments)
EN 60 068-2-6 Vibration test
EN 60068-2-27 Shock test
EN 60721-3-3 Classification of ambient conditions
EN 60721-3-2 Classification of ambient conditions
EN 60721-3-1 Classification of ambient conditions
UL 508 Industrial Control Equipment
Fig.4-6: Used standards
The electronic products described in the project planning manual comply with
the requirements and goals of the following EC guideline and with the agreed
European standards:
EMC guideline 2004/108/EC
The electronic products described in the project planning manual comply with
the requirements on the operation within the industrial environment:
Standard Title
DIN EN Electromagnetic compatibility (EMC)
61000-6-4
Volume: 6-4: Generic standards - Immunity for in‐
(VDE 0839-6-4) dustrial environments (IEC 61000-6-4:2006)
DIN EN Electromagnetic compatibility (EMC)
61000-6-2
Volume: 6-2: Generic standards - emitted interfer‐
(VDE 0839-6-2) ence for industrial environments (IEC
61000-6-2:2005)
Fig.4-7: Electromagnetic compatibility (EMC) standards
The electronic products described in this project planning manual do not fall
under the machines listed in the EC guidelines. Therefore, explanations are not
required for the 89/392/EMC guideline and do not exist.
89/392/EMC, the EC guideline for machines, specifies the requirements on a
machine. In this guideline, a machine is defined as a combination of the com‐
ponents or mechanisms combined with each other. The described products
belong to the electrical equipment of a machine. Therefore, they are to be in‐
cluded in the declaration of conformity of the machine manufacturer.
The standard EN 60204-1 (safety of machinery, general requirements on the
electrical equipment of the machines) can be used for the electrical equipment
of the machines.
The CE marking is only valid for the device in its delivery status (ex
works). After modifying the device, e.g. after plugging additional
extension cards, CE compliance must be checked.
Electric Drives | Bosch Rexroth AG
and Controls
17/45
Technical Data
Edition
September
2007
March 2006