NEC BladeServer Express5800 Series User Manual page 31

2-6 General Description
8 ID switch
Press this switch to turn on or off the ID lamp.
9 ID lamp (blue)
The lamp identifies the CPU blade in the system. The lamp is lit by a switch or software
command.
When the recognize command is received, the lamp blinks. If you press the ID switch, the
lamp goes on.
10 Eject lever
Pull the lever to remove the CPU blade from the Blade Enclosure.
11 SUV connector
This connector sends or receives various signals.
The K410-150(00) SUV cable is connected to this connector.
12 Hard disk drive (left: slot 0, right: slot 1)