Sony ZRD-1 Installation Manual page 55

4. Attach the unit alignment tool to the display unit.
(1) Attach the unit alignment tool and start it. (Refer to steps 4-(1) to 4-(5) in Section 2-4-3.)
(2) Select the previously set display unit on the monitor. ([Layout] button, orange → blue)
(3) Select the display unit to be set on the monitor. (orange)
5. Align the display unit in the Z and X directions.
(1) Insert the eccentric pins (short) into the two Z adjusting holes and the X adjusting hole. Insert the
hexagon wrench into the eccentric pins (short).
. Insert the eccentric pin (short) into the X adjusting hole of one of the two joint comas (BTM).
If you insert the eccentric pins into both X adjusting holes, the adjustment cannot be made.
. Insert the eccentric pins (short) vertically all the way to the end.
. If you have difficulty in inserting the eccentric pins (short) into the Z adjusting holes or X
adjusting hole, slightly rotate the eccentric pins (short) to find the position into which they can
be inserted.
Joint comas (BTM)
ZRD-1/ZRD-2/ZRCT-100/ZRCT-200
Eccentric pins (short)
X adjusting hole
Z adjusting hole
Insert the eccentric pin (short)
into the X adjusting hole of one of
the two joint comas (BTM).
Hexagon wrench
2-21 (E)