Table of Contents
Advertisement
Figure 22
5.
Remove the drain plug.
6.
Allow the oil to drain and replace the drain plug.
7.
Remove the dipstick
oil into the fill hole until the oil is between the
upper and lower limit on the dipstick; refer to
Checking the Engine-Oil Level (page
8.
Install and secure the dipstick.
9.
Wipe up any spilled oil.
Inspecting and Cleaning the
Engine-Oil Filter
Service Interval: After the first 50 hours
Every 400 hours
1.
Remove the oil-filter retaining bolt.
2.
Pull the oil-filter cap out and remove the oil filter.
Figure 23
3.
Clean the oil filter or replace it if it is damaged.
4.
Install the oil filter.
5.
Make sure that the oil-filter cap is fully seated.
6.
Install and tighten the oil-filter retaining bolt.
7.
Add new engine oil; refer to
Oil (page
17).
(Figure
21) and slowly pour
17).
Servicing the Engine
8.
Warm up the engine by running it for 5 minutes,
and check for any engine oil leaks.
9.
After the engine is warm, turn it off and let it sit
for 10 minutes.
10.
Check the engine oil level by fully inserting, but
not screwing in, the dipstick.
11.
Add engine oil as needed; refer to
Engine Oil (page
g038412
g038413
18
Servicing the
17).
Advertisement
Table of Contents
