Table of Contents
Advertisement
4.
Use a bolt (5/16 x 3/4 inch), a washer, and a nut
(5/16 inch) to mount the negative cable to the
negative battery terminal.
Connecting the Pump to
the Tank
Ensure that the frame of the fluid mixer and the frame
of the tank are secured to a strong surface, with
an adequate fastener through each mounting hole
(Figure
4).
Note:
Ensure that the mixer and the tank are in a
position that allows the hoses to connect them without
stretching or kinking.
Underside shown
1. Mounting holes in tank
frame
1.
Locate the suction hose connected to the bottom
of the tank, and pull the loose end out from
under the tank.
2.
Use a hose clamp (provided with the transfer
hose) to connect the loose end of the suction
hose to the pump inlet on the mixer as shown in
Figure
5,
Figure
Figure 4
2. Mounting holes in mixer
frame
6, and
Figure
7.
1. Circulation hose
g024044
1. Fitting
2. Hose clamp
1. Locknut
3.
Tighten the hose clamp by tightening the locknut.
4.
Use 2 hose clamps (provided) to connect the
circulation hose to the top of the tank and the
top of the mixer as shown in
and
Figure
5.
Tighten the hose clamps by tightening the
locknuts.
7
Figure 5
2. Suction hose
Figure 6
3. Hose
Figure 7
Figure
7.
g024043
g025173
g024041
5,
Figure
6,
Advertisement
Table of Contents
