Replacing The Water Separator Filter; Checking The Fuel Lines And Connections; Bleeding The Fuel System; Draining The Fuel Tank(S) - Toro TX 1300 Operator's Manual

Replacing the Water
Separator Filter
Service Interval: Every 500 hours
1. Park the machine on a level surface, engage the
parking brake, and lower the loader arms.
2. Shut off the engine and remove the key.
3. Remove the rear cover; refer to
Rear Cover (page
4. Clean the area where the water separator filter
mounts.
Figure 76
1. Water separator
5. Remove the filter canister and clean the
mounting surface
6. Lubricate the gasket on the new filter canister
with clean oil.
7. Fill the canister with fuel.
8. Install the filter canister by hand until the gasket
contacts the mounting surface, then rotate it an
additional 1/2 turn.
9. Install the rear cover.
Checking the Fuel Lines
and Connections
Service Interval: Every 400 hours/Yearly (whichever
comes first)
Inspect the fuel lines and connections for deterioration,
damage, or loose connections. Tighten any loose
connections and contact your Authorized Service
Dealer for assistance in fixing damaged fuel lines.
Removing the
44).

Bleeding the Fuel System

You must bleed the fuel system before starting the
engine if any of the following situations have occurred:
•
Initial startup of a new machine
•
The engine has ceased running due to a lack of
fuel.
•
Maintenance has been performed upon
fuel-system components (e.g., filter replaced).
1. Turn the key to the RUN position.
2. Let the fuel pump run for 2 minutes prior to
starting the machine.

Draining the Fuel Tank(s)

Service Interval: Every 500 hours
Have an Authorized Service Dealer drain and clean
the fuel tank(s).
g361076
50