Toro TX 1300 Operator's Manual page 35

11. The engine computer checks the engine state
and fault information. The InfoCenter may
display the following messages:
Check Message and Corrective Action Table
Message
12. The InfoCenter displays the home screen and
the regeneration acknowledge icon
in the lower right corner of the screen as the
regeneration processes.
Note:
While the DPF regeneration
runs, the InfoCenter displays the high
exhaust-temperature icon
Corrective Action
Exit the regeneration
menu and run the machine
until the time since last
regeneration is greater
than 50 hours; refer to Time
Since Last Regeneration
(page 30).
Troubleshoot the engine
fault and retry DPF
regeneration.
Start and run the engine.
Run the engine to warm
the coolant temperature to
60°C (140°F).
Change the engine speed
to low idle.
Troubleshoot the engine
computer condition and
retry DPF regeneration.
appears
.
13. When the engine computer completes a
parked or recovery regeneration, the InfoCenter
displays A
DVISORY
displays A
DVISORY
exit to the home screen.
Canceling a Parked or Recovery Regeneration
1. In the DPF Regeneration menu, scroll to P
R C
EGEN ANCEL
2. Press the right button to cancel the regeneration.
35
#183; if it fails, the InfoCenter
#184. Press the left button to
Figure 45
or R R C
ECOVERY EGEN
Figure 46
g362807
ARKED
.
ANCEL
g362918