Toro TX 1300 Operator's Manual page 14

Loader-Valve Lock
The loader-valve lock secures the loader
arm/attachment-tilt lever so that you cannot push it
forward. This helps to ensure that no one accidentally
lowers the loader arms during maintenance. Secure
the loader valve with the lock, in addition to the
cylinder locks, any time you need to shut off the
machine with the loader arms raised. Refer to
the Cylinder Locks (page
To set the lock, lift it so that it clears the hole in the
control panel and swing in front of the loader-arm
lever. Push it down into the locked position.
1. Loader-valve lock
42).
Figure 11
Joystick Controls
Using
1. Attachment primary
function (hydraulic
attachments only)
2. Attachment secondary
function (certain
attachments only)
Note:
The loader arms may not extend when they
are fully raised due to trapped pressure; lower the
arms slightly to relieve pressure and extend them.
g358630
WARNING
Moving the machine while the loader arms
are extended may affect the stability of the
machine.
Minimize machine movement while the loader
arms are extended.
Auxiliary-Hydraulics Lock Switch
Engage the forward or reverse hydraulics, then use
your right foot to press the lock switch to continue the
flow and free your hand for other controls.
1. Auxiliary-hydraulics lock switch
14
Figure 12
3. Extend and retract the
loader arms
Figure 13
g318281
g358628