Toro TX 1300 Operator's Manual page 32

Periodic Reset Regeneration
If the engine has not completed a successful Reset,
Parked, or Recovery regeneration in the previous 100
hours of engine operation, the engine computer will
attempt to perform a reset regeneration.
Setting the Inhibit Regen
Reset Regeneration Only
A reset regeneration produces the elevated engine
exhaust temperatures. If you are operating the
machine around trees, brush, tall grass, or other
temperature-sensitive plants or materials, you can
use the Inhibit Regen setting to prevent the engine
computer from performing a reset regeneration.
Important:
When you shut off the engine and
start it again, the Inhibit Regen setting defaults
to O .
FF
Note:
If you set the InfoCenter to inhibit regeneration,
the InfoCenter displays A
15 minutes while the engine requests a reset
regeneration.
1. Access the DPF Regeneration menu and scroll
down to I R
NHIBIT
2. Press the right button to change the inhibit
regeneration setting to O
#185 every
DVISORY
Figure 29
.
EGEN
Figure 30
or O .
N FF
Figure 31
Allowing a Reset Regeneration
The InfoCenter displays the high exhaust-temperature
icon when the reset regeneration is in process.
Note:
If Inhibit Regen is set to O
displays A
DVISORY
inhibit regeneration setting to O
the reset regeneration.
Note:
If the InfoCenter displays A
the engine to full throttle (high idle) to allow the reset
regeneration to continue.
g224692
Note:
When the reset regeneration completes, the
high exhaust-temperature icon
the InfoCenter screen.
g362745
g365224
32
, the InfoCenter
N
#185 . Press the right button to set
and continue with
FF
Figure 32
DVISORY
Figure 33
disappears from
g362746
#186, set
g224395