Toro TX 1300 Operator's Manual page 52

Charging the Battery
WARNING
Charging the battery produces gasses that
can explode.
Never smoke near the battery and keep sparks
and flames away from battery.
Important:
Always keep the battery fully charged
(1.265 specific gravity). This is especially
important to prevent battery damage when the
temperature is below 0°C (32°F).
1. Remove the battery from the machine; refer to
Removing the Battery (page
2. Charge the battery for 4 to 8 hours at a rate of 3
to 4 A. Do not overcharge the battery.
Figure 79
1. Positive battery post
2. Negative battery post
3. When the battery is fully charged, unplug
the charger from the electrical outlet, then
disconnect the charger leads from the battery
posts.
51).
g003792
3. Red (+) charger lead
4. Black (-) charger lead
Cleaning the Battery
Note:
Keep the terminals and the entire battery case
clean, because a dirty battery discharges slowly.
1. Park the machine on a level surface, engage
the parking brake (if equipped), and lower the
loader arms.
2. Shut off the engine and remove the key.
3. Remove the battery from the machine;
Removing the Battery (page
4. Wash the entire case with a solution of baking
soda and water.
5. Rinse the battery with clear water.
6. Coat the battery posts and cable connectors with
Grafo 112X (skin-over) grease (Toro Part No.
505-47) or petroleum jelly to prevent corrosion.
7. Install the battery; refer to
(page 53).
52
51).
Installing the Battery