Toro TX 1300 Operator's Manual page 41

Maintenance Service
Interval
Every 100 hours
Every 250 hours
Every 400 hours
Every 500 hours
Every 800 hours
Every 1,000 hours
Every 1,500 hours
Every 3,000 hours
Yearly or before storage
Every 2 years
Important:
Refer to your engine owner's manual for additional maintenance procedures.
Maintenance Procedure
• Remove the air-cleaner cover and clean out debris. (Clean more often in dirty or
dusty conditions.)
• Check the cooling system hoses.
• Check the alternator-belt tension.
• Check the hydraulic lines for leaks, loose fittings, kinked lines, loose mounting
supports, wear, weather, and chemical deterioration.
• Check for dirt buildup in the chassis. (More often in dirty conditions.)
• Check the alternator/fan belt tension.
• Change the engine oil and filter.
• Check the fuel lines and connections for deterioration, damage, or loose connections.
• Replace the hydraulic oil and filters (if not using Toro fluid).
• Service the air cleaner. (Service more frequently in extremely dusty or dirty
conditions).
• Replacing the water separator filter.
• Drain and clean the fuel tank(s)—Authorized Service Dealer only.
• Replace the alternator/fan belt (refer to the engine owner's manual for instructions).
• Change the engine coolant.
• Replace the hydraulic oil and filters (if using Toro fluid).
• Replace all moving hydraulic hoses.
• Disassemble, clean, and assemble the soot filter of the DPF or if engine faults
3251 0, 3720
FMI SPN FMI
• Check and adjust the track tension.
• Touch up chipped paint.
• Replace all moving hydraulic hoses.
0, or 3720 16 display in the InfoCenter.
SPN FMI
41
SPN