Toro TX 1300 Operator's Manual page 33

Parked or Recovery Regeneration
•
When the engine computer requests either a
parked regeneration or a recovery regeneration,
the regeneration request icon
InfoCenter.
•
The machine does not automatically perform a
parked regeneration or a recovery regeneration,
you must run the regeneration through the
InfoCenter.
Parked Regeneration Messages
When the engine computer requests a parked
regeneration, the following messages display in the
InfoCenter:
•
Engine warning SPN 3720, FMI 16
Figure 34
•
A #188 Parked regeneration required
DVISORY
Note:
Advisory #188 displays every 15 minutes.
Figure 35
Recovery Regeneration Messages
When the engine computer requests a recovery
regeneration, the following messages display in the
InfoCenter:
Engine warning SPN 3719, FMI 0
Refer to the Service Manual or your Authorized
Service Dealer for details.
Figure 36
DPF Status-Limitation
•
displays in the
•
g213863
Performing a Parked or Recovery
g224397
Regeneration
The exhaust temperature is hot (approximately
600°C (1,112°F) during DPF regeneration. Hot
exhaust gas can harm you or other people.
• Never operate the engine in an enclosed
• Make sure that there are no flammable
• Never touch a hot exhaust system
• Never stand near or around the exhaust
g213867
Important:
DPF regeneration if you increase the engine speed
from low idle or release the parking brake.
33
If the engine computer requests a parked
regeneration or is processing a parked
regeneration, the P
ARKED
the lock icon appears on the screen.
Figure 37
If the engine computer requests a recovery
regeneration or is processing a recovery
regeneration, the R
ECOVERY
and the lock icon appears on the screen.
Figure 38
CAUTION
area.
materials around the exhaust system.
component.
pipe of the machine.
The computer of the machine cancels
R option locks and
EGEN
g224625
R option locks
EGEN
g224628