Toro TX 1300 Operator's Manual page 54

systems are off and at the same rated system
voltage. These instructions are for negative
ground systems only.
4. Connect the positive (+) cable to the positive (+)
terminal of the discharged battery that is wired
to the starter or solenoid as shown in
1. Positive (+) cable on
discharged battery
2. Positive (+) cable on
booster battery
3. Negative (–) cable on the
booster battery
4. Negative (–) cable on the
engine block
5. Connect the other end of the positive (+) jumper
cable to the positive terminal of the battery in
the other machine.
6. Connect an end of the negative (-) jumper cable
to the negative post of the battery in the other
machine.
7. Connect the other end of the negative (-) jumper
cable to a ground point, such as an unpainted
bolt or chassis member.
8. Start the engine in the other machine. Let it run
a few minutes, then start your engine.
9. Remove the cables in the reverse order of
connection.
10. Install the front cover.
Figure
Figure 81
5. Booster battery
6. Discharged battery
7. Engine block
81.
g012785
54