Toro TX 1300 Operator's Manual page 34

1. Ensure that the machine has at least the
specified amount fuel in the tank for the type of
regeneration you are performing:
•
Parked Regeneration: 1/4 tank of fuel
•
Recovery Regeneration: 1/2 tank of fuel
2. Park the machine on a level surface, in an area
outside away from combustible materials.
3. Engage the parking brake and lower the loader
arms.
4. Set the throttle to the low I
5. In the DPF Regeneration menu, scroll to P
R S or R
EGEN TART
the right button to start the regeneration.
Figure 39
6. When prompted, verify that you have that the
fuel level is sufficient, as indicated in step 1.
Press the right button to continue.
Figure 40
Recovery Regeneration screen shown.
7. At the DPF checklist screen, verify that the
parking brake is engaged and the engine speed
is set to low idle. Press the right button to
continue
Figure 41
Recovery Regeneration screen shown.
position.
DLE
R S
ECOVERY EGEN TART
8. At the I
right button to continue.
Recovery Regeneration screen shown.
9. The InfoCenter displays the I
ARKED
. Press R
EGEN
g362809 Recovery Regeneration screen shown.
10. The InfoCenter displays the time to complete
message.
•
Parked regeneration requires up to 30
minutes to complete.
•
Recovery regeneration requires up to 3
hours to complete.
Note:
it is initiated, refer to
g227678
Recovery Regeneration (page
g227679
34
DPF R screen, press the
NITIATE EGEN
Figure 42
message.
Figure 43
If you must cancel the regeneration after
Canceling a Parked or
Figure 44
g224630
DPF
NITIATING
g227681
35).
g224406
g224416