Kenwood DV-2070 Instruction Manual page 17

~u. r nw>~,ifiil»ilit<~Tiiai ii '' '-f*t • /-•- | - r a,*
Make connection as shown below. When connecting the
related system components, refer also to the instruction
manuals of the related components.
Caution: Do not plug in the power lead until all connec¬
tions are completed.
_DV-5070 jEn/Kl
The VIDEO OUTPUT jacks should be connected directly to the TV. Do
not connect them to the TV via a VCR Otherwise the played video
may be disturbed due to the copy protection function.
Initial setup
Set initial setup |6 TV Aspect! according to the aspect ratio 14:3 or
16:9) of your TV —
To wail AC outlet
Monitor TV
(commercially available)
* If you want to use tne macro
function of a KENWOOD
AUDIO VIDEO SURROUND
RECEIVER (optional!, connect
this player to a wall AC outlet.
Be sure to set the POWER
switch on the front panel of
this unit to OFF when you are
going to leave the unit
unattended for going out of
the house, etc.
H | S-VIDEO OUT/S-VIDEO cord (commercially available;
| VIDEO OUTA/ideo cord (75i2coaxiali (commercially available)
S-VIDEO IN/S-VIDEO cord (provided)
I? T^f J VIDEO IN.A/ideo cord !75Ucoaxiall (provided)
^ I FRONT L/'R IN/Audio cord iprovidedi
1 OPTICAL IN/Gptical fiber cable (provided!
COAXIAL IN/Digital cord l75iicoaxial) (commercially available)
Connect the cords and cables according to the jacks available on the connected AV receiver.
AV receiver with 6-channei input (commercially available!
Front SDeaker (R!
Surround
sDeader(R;
Stereo system (commercially available)
* The connected components shown here are typical examples.
R) 1 Connect all cords firmly. If connections are loose, there could be loss of sound or noise produced.
(gpt^l 2. When plugging and unplugging connection cords, be sure to first remove the power cord from the AC outlet. Plugging/unplugging
** connection cords without removal of the power cord can cause malfunctions or damage to the unit.