Table of Contents
Advertisement
2. Safety instructions
Demands on the user
- For all activities (operation, maintenance, repair, etc.) the details of the operating
- The operator must avoid any working method which would impair the safety of the
- The operator must take care that only authorized personnel works at the linear feeder.
- The user is obliged to inform the operator immediately about any changed conditions at
Noise emission
The noise level at the place of operation depends on the complete equipment and the material
to be transported. The determination of the noise level according to the EC-Regulations
"Machinery" can therefore only be carried out at the place of operation.
If the noise level at the place of operation exceeds the limit permitted, noise prediction hoods
may be used, which we offer as accessory parts (see catalogue).
Standards and regulations
The device was built according to the following standards and regulations:
- Low voltage directive 2014/35/EU
- EMC directive 2014/30/EU
We assume that our product is to be integrated in a fixed machine. The provisions of the
EMC directive 2014/30/EU must be considered by the user.
- Applied harmonized Standards
WARNING
6
instructions must be observed.
linear feeder.
the linear feeder that could endanger safety.
The linear feeder may only be installed, put into operation and
serviced by expert personnel.
WARNING
Since the electromagnet-field may have an impact on persons
with pacemakers it is recommended to keep a minimum
distance of 25 cm.
DANGER
- Unplug the main power plug when plugging / unplugging the
cord.
- Unplug the main power plug when performing adjustment
DANGER
and maintenance.
EN 60204-1
When transporting and shipping, please take actions to prevent
accidents for transporting and shipping.
Part Feeding 7.0 Hopper & Hopper Controller Rev.5
Advertisement
Table of Contents
